KENWOOD TK 880 REPETER SERIAL NUMBERS

(See вЂњAlpha- numeric Two-way Paging FunctionвЂќ for details) Used to select whether system scan routines are used during system scan. Scan del/add 1) Trunking format Press this key to enter the message mode.Mined DTMF ID (Begin of TX) will be sent automatically. DTMF ID (BOT) The FPU (KPG-49D) enables programmable keys to se- In conventional mode, if you press this key, a predeter- lect the following functions.The antenna system selection depends in both trunking format (LTR model) and conventional for- on many factors and is beyond the scope of this manual. Antenna system The TK-880/880H is a UHF FM radio designed to operate Control station. INSTALLATION PLANNING вЂ“ CONTROL STATIONS 1. Transmitter frequency, deviation, and power output. Testing INTRODUCTION The radio should be tested complete with all cabling and SCOPE OF THIS MANUAL accessories as they will be connected in the final installa- This manual is intended for use by experienced techni- tion.

KENWOOD TK 880 REPETER SERIAL NUMBERS

In terms of the products with the serial numbers earier than 30200001, refer to the TK-880/H service manual as per part No.

B51-8582-00 ( N ) 1370 This service manual applied to products with 30200001 or subsequent serial numbers.

PC Software programming for TK-880: >KPG-60Dsoftware at Edit / Channel Information. Kenwood Programming Software for TK-280, TK-380, TK-480, TK-780, TK-880, TK-980, TK-981 Two-way Radios PC Programming Cable needed for these radios is either the KPG-36, which comes with a Serial port plug or the KPG-36UM, which comes with a.

Since we're not Kenwood geeks the Repeater- Builder staff can't. The three tables below were received as two anonymous emails in December.

Kenwood tk 880 repeter